Panasonic EBL128 Planning Instructions page 6

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
13 Functions / Services / Features _______________ 93
13.1 Sensor value _____________________________________ 93
13.2 Week average sensor value __________________________ 93
13.3 Decision value ____________________________________ 94
13.4 Alarm algorithms for smoke detectors / Detection levels /
Offsets 94
13.4.1 Alarm algorithm / Alternative alarm algorithm ______ 95
13.4.2 Filtering algorithm ____________________________ 96
13.4.3 Smouldering smoke algorithm ___________________ 98
13.4.4 Performance factor ____________________________ 99
13.5 Algorithms for analog heat detectors _________________ 100
13.5.1 Class A1 algorithm ___________________________ 100
13.5.2 Class A2 S algorithm _________________________ 101
13.5.3 Class B S algorithm ___________________________ 101
13.6 Self verification __________________________________ 101
13.7 Minimum / Maximum sensor values __________________ 102
13.8 2-zone / 2-address dependence (Co-incidence alarm) _____ 102
13.8.1 2-zone dependence ___________________________ 102
13.8.2 2-address (-unit) dependence ___________________ 103
13.8.3 Reset of 2-zone / 2-address dependence (co-incidence
alarm 103
13.9 Delayed alarm ___________________________________ 103
13.10 Alarm Verification Facility _______________________ 104
13.11 Alert Annunciation _____________________________ 105
13.12 Alarm Acknowledgement Facility (AAF) ____________ 106
13.13 Quiet alarm ___________________________________ 109
13.14 Fire alarm type A and Fire alarm type B _____________ 109
13.14.1 Fire alarm type B ___________________________ 110
13.14.2 Fire alarm type A __________________________ 110
13.15 Disable zones, alarm points, outputs, etc. ____________ 110
13.15.1 Disable zone ______________________________ 111
13.15.2 Disable zone-address ________________________ 111
13.15.3 Disable output _____________________________ 111
13.15.4 Disable all control, ventilation, exting or interlocking
outputs 111
13.15.5 Disable / Re-enable alarm devices _____________ 111
13.15.6 Disable / Re-enable outputs for routing equipment _ 111
13.15.7 Disable / Re-enable alert annunciation function ___ 111
13.15.8 Disconnect / Re-connect COM loop ____________ 112
13.15.9 Disconnect / Re-connect zone line input _________ 112
13.15.10 Disconnect / Re-connect addressable zone interface
input 112
13.15.11 Disable interlocking output ___________________ 112
13.16 Test mode ____________________________________ 112
13.17 Test alarm devices ______________________________ 112
13.18 Test of routing equipment ________________________ 113
EBL128 Planning Instructions V2.0.x
4