Panasonic EBL128 Planning Instructions page 35

Panasonic Eco Solutions Nordic AB
MEW01622 Rev: -
See also chapter "Current consumption", page 162 and drawing 128-
11.
The following units can be connected to the COM loop in NORMAL
mode (if nothing else is stated):
NOTE!
4301 in NORMAL mode = 3304 in NORMAL mode.
4300 in NORMAL mode = 3316 in NORMAL mode.
The
3361 I/O Unit for Fan control
4593 only.
The
AAFC Alarm Acknowledge Facility Control
Australian market only.
(listed below) can be found in old installations and
Obsolete loop units
can be used in EBL128 installations as well.
& plugged in base
2300 2304
= & in 2312 mode.
2304 4301 3304
NOTE! When one or more of the
used on a COM loop, only technical address 1-127 can be used.
Address setting / Technical address
Each COM loop unit has to have a unique technical address (001-
255). This address and the mode are set with an Address Setting Tool
3314 / 4414. For EBL128 is the NORMAL mode used (default) if
nothing else is stated. To set the detectors 440x in Advanced mode
the Address Setting Tool 4414 has to be used.
EBL128 Planning Instructions V2.0.x
is used with the Fan control panel
is used on the
.
2312
Obsolete loop units
33
listed above are