Advertisement
ViewPoint 8650C
User Guide
Parameter
Area code
Password
IP address
Port
Step 4 Set the parameters according to the sample values in
then click OK.
----End
5.2.2 Adding a Site
Procedure
Step 1 Click Site Management in the navigation bar.
Step 2 Right-click the primary list and choose Add from the shortcut menu to display the General
Information dialog box, as shown in
Issue 10 (2013-07-20)
Description
from the drop-down list.
When the active/standby switchover is activated, the
area code of the active MCU will be switched over to
the standby MCU. Therefore, the area code of the
standby MCU can be selected freely.
The area code that the MCU belongs to. In the service
area named Beijing, the area code has been added as the
IP-type prefix.
The password used to connect the MCU and the RM.
NOTE
The connection password should be consistent with the
Password in
5.1.2 Configuring the Parameters Between the
8650C MCU and the
RM.
he IP address of the GE0 network port of the 8650C
MCU.
The port number that the MCU communicates with the
RM.
NOTE
The port number should be consistent with the value of
Listening port in
5.1.2 Configuring the Parameters Between the
8650C MCU and the
RM.
Figure
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Holding a Simple Conference
Table 5-10
to add an 8650C MCU, and
5-11.
Setting
Example: 010.
Example:
123456.
Example:
200.54.1.101.
Example:
5000.
48
Advertisement
