Programmable Parameters - Siemens SIMATIC Manual

Analog modules
6.4 Analog input module SM 331; AI 8 x 16 Bit; (6ES7331-7NF10-0AB0)
6.4.2

Programmable parameters

Introduction
For information on programming analog modules, refer to the chapter Programming analog
modules (Page 294).
Parameter
Table 6- 11 Overview of parameters of SM 331; AI 8 x 16 Bit
Parameters
Enable
•
Process interrupt when limit value
is exceeded
•
Process interrupt at end of cycle
•
Diagnostics interrupt
Process interrupt trigger
•
High limit
•
Low limit
Diagnostics
•
Group diagnostics
•
Line continuity check
Measurement
•
Module operating mode
•
Noise suppression
•
Smoothing
•
Measurement type
disabled
Voltage
Current (4-wire transducer)
See also
Diagnostics messages of analog input modules (Page 296)
Programming analog modules (Page 294)
324
Range of values
yes/no
yes/no
yes/no
32511 to -32512
-32512 to 32511
yes/no
yes/no
•
8 channels
•
4 channels
50 Hz
60 Hz
400 Hz
50/60/400 Hz
•
none
•
weak
•
medium
•
strong
•
Measuring range:
•
± 5 V
•
1 V to 5 V
•
± 10 V
•
0 mA to 20 mA
•
4 mA to 20 mA
•
± 20 mA
Defaults Parameter type
no dynamic
no dynamic
no dynamic
- dynamic
-
dynamic
no static
no
yes dynamic
no
50/60/400 Hz
none dynamic
dynamic
± 10 V
4 mA to 20 mA
Scope
Module
Channel
Channel
Channel
Channel
Module
Channel group
Channel group
Channel group
S7-300 Module data
Manual, 06/2017, A5E00105505-AJ