Parameters Of Analog Input Modules - Siemens SIMATIC Manual

Parameter sets of signal modules
A.6 Parameters of analog input modules
A.6

Parameters of analog input modules

Parameter
The table below lists all parameters you can set for analog input modules.
The comparison illustrates the parameters you can edit:
● in
● using SFC55 "WR_PARM"
Parameters set in
(refer to the
Table A- 6 Parameters of analog input modules
Parameters
Diagnostics: Group diagnostics
Diagnostics: with wirebreak monitoring
Temperature unit
Temperature coefficient
Smoothing
Diagnostic interrupt enable
Hardware interrupt when limit exceeded
End of cycle interrupt enable
Interference frequency suppression
Measurement type
Measuring range
High limit
Low limit
Note
To enable diagnostic interrupts in the user program at data record 1, you first need to enable
diagnostics at data record 0 in
534
STEP 7
STEP 7 can also be transferred to the module using SFC56 and SFC57
STEP 7 manuals).
Data record num-
ber
0
1
STEP 7
.
Programmable, using ...
... SFC55 ... PG
No Yes
no yes
no yes
no yes
no yes
yes yes
yes yes
yes yes
yes yes
yes yes
yes yes
yes yes
yes yes
S7-300 Module data
Manual, 06/2017, A5E00105505-AJ