Division Operation - NEC 78K0 User Manual

8-bit single-chip microcontrollers
Hide thumbs Also See for 78K0:
Table of Contents

Advertisement

18.4.2 Division operation

• Initial setting
1. Set operation data to multiplication/division data register A0 (MDA0L and MDA0H) and
multiplication/division data register B0 (MDB0).
2. Set bits 0 (DMUSEL0) and 7 (DMUE) of multiplier/divider control register 0 (DMUC0) to 0 and 1,
respectively. Operation will start.
• During operation
3. The operation will be completed when 32 internal clocks have been issued after the start of the
operation (intermediate data is stored in the MDA0L and MDA0H registers and remainder data register
0 (SDR0) during operation, and therefore the read values of these registers are not guaranteed).
• End of operation
4. The result data is stored in the MDA0L, MDA0H, and SDR0 registers.
5. DMUE is cleared to 0 (end of operation).
6. After the operation, an interrupt request signal (INTDMU) is generated.
• Next operation
7. To execute multiplication next, start from the initial setting in 18.4.1 Multiplication operation.
8. To execute division next, start from the initial setting in 18.4.2 Division operation.
426
CHAPTER 18 MULTIPLIER/DIVIDER
*
User's Manual U15947EJ2V0UD

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

78kf1

Table of Contents