Human Readable Text Settings: Brv - Panasonic LP-GS Series Serial Communication Command Manual

3-7-2 Human readable text settings: BRV

Sets the character conditions to mark the character strings of bar code/2D code as the human readable text.
⿎ Setting request data / response data for readout
Start
BRV Sub command
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
BRV
code
⿎ Data description
Name Omit
Object No.
Relative X-position
Relative Y-position
Character height
Character width
Character spacing
Linefeed spacing
Font No.
Bold line width
104
[Object No.], [Relative X-position],
[Relative Y-position], [Character height],
[Character width], [Character spacing],
[Bold line width], [Laser power correction],
[Scan speed correction], [Linefeed]
[Object No.]
R
Max. 6-byte
Data length
[byte]
For bar code/2D code objects excepting
2D side of composite code:
"0000"–"1999" or "0000.0"–"1999.0"
– Max. 6*
For 2D side of composite codes:
"0000.1"–"1999.1"
Y Max. 8*
"-999.999"–"+999.999" [mm]
Y Max. 8*
Model
Y Max. 7*
LP-GS051(-L)
LP-GS052
LP-RC350S
Y Max. 7*
LP-RF200P
Model
Y Max. 7*
LP-GS051(-L)
LP-GS052
LP-RC350S
Y Max. 7*
LP-RF200P
Y Max. 2* "01"–"50"
Y Max. 5* "0.000"–"6.000" [mm]
[Linefeed spacing], [Font No.],
Max. 75-byte
(Check sum)
Data contents
Setting range [mm]
"000.100"–"055.000"
"000.060"–"030.000"
"000.100"–"085.000"
"000.100"–"090.000"
Setting range [mm]
"000.000"–"055.000"
"000.000"–"030.000"
"000.000"–"085.000"
"000.000"–"090.000"
ME-LPGS-SR-5
(Check
sum)
End code
Remarks
• Excepting 2D side of the
composite codes, you do not
need to specify the number
after the decimal point.
• To set the human readable text
to 2D side of the composite
codes, add ".1" after the object
number.
• Only "0" or "1" can be specified
after the decimal point.
• It is the relative position to the
code center.
• Specifies the left lower position
of the first character.
• For the composite codes, the
positions of 1D and 2D side
can be separately specified.
For the composite codes, the
settings from "character height"
are applied to both 1D and 2D
side. If these settings were
already set in either 1D or 2D
settings, end the data here. No
subsequent data including a
separator "," is required.
End code