Panasonic LP-GS Series Serial Communication Command Manual page 97

3. When the code type is NW-7
Name Omit
Object No. –
X-position Y
Y-position Y
Rotation angle Y
Code type (Y)
Bar code height Y
Narrow element
Y
width
Quiet/narrow ratio Y
Wide/narrow ratio Y
Check character Y
Start/stop
Y
character
Invert Y
Human readable
Y
text
Code marking
Y
direction
Laser power
Y
correction
Scan speed
Y
correction
Total data length
* Setting request data are variable length.
Data
length Data contents
[byte]
Max. 4* "0000"–"1999"
Max. 8*
"-999.999"–"+999.999" [mm]
Max. 8*
Max. 8* "-180.000"–"+180.000" [°]
2 "03": NW-7
Model
LP-GS051(-L)
Max. 7* LP-GS052
LP-RC350S
LP-RF200P
Max. 5* "0.050"–"1.000" [mm]
Max. 4* "00.0"–"20.0"
Max. 3* "1.8"–"3.4"
"0": OFF
1
"1": ON
"A": Start/Stop Character A
"B": Start/Stop Character B
1
"C": Start/Stop Character C
"D": Start/Stop Character D
"0": Do not invert
1
"1": Invert
"0": OFF
1
"1": ON
"0": One-way direction
1
"1": Alternate
Max. 3* "000"–"999" [%]
Max. 3* "001"–"999" [%]
Max. 75 It is the length including the separator ",".
ME-LPGS-SR-5
It is the center coordinate of the
code.
The rotation center is the center
of the code symbol.
Setting range [mm]
"000.050"–"055.000"
"000.050"–"030.000"
"000.050"–"085.000"
"000.050"–"090.000"
Specify a larger value than the
line width in the object group
settings.
Ratio of the quiet zone width to
narrow element width.
Ratio of the wide element width
to narrow element width.
Set "0" to mark a bar, "1" to mark
a space.
The correction ratio is calculated
using the value set at the laser
settings as 100%.
Remarks
97