Command List - Panasonic LP-GS Series Serial Communication Command Manual

3-1 Command List

Type Name
Command reception permission
Laser pumping
Shutter open/close
Marking trigger
Marking trigger (at regular intervals)
*1
Trigger mode
Trigger delay
Guide laser *2
Status checking
Marking end verification
File selection by number
File selection by name
Overwrite file
Save file to different number
File name
Code Functions
MKM Controls the reception permission for the settings
by communication commands.
LSR Controls the laser pumping ON/OFF.
SHT Controls the internal shutter opening/closing.
MRK Inputs marking trigger (laser radiation startup
signal).
MRK Controls to start or to stop the on-the-fly marking
at regular intervals.
TMS Specifies how you will input TRIGGER IN (marking
start signal) by selecting "single trigger" or
"continuous trigger".
DLY Sets the delay time from trigger input to starting
trigger processing (lasing) operation.
GID Controls radiation of red guide laser for marking
position confirmation.
STS Reads out the laser marker status including
marking trigger ready status and error occurrence
status.
MST Enables automatic response of marking result (e.g.
normal end, and error occurrence, etc.) at the end
of marking.
FNO Specifies the file number to change the file.
FNN Specifies the file name to change the file.
FOR Overwrites the file being edited onto the laser
marker.
FRG Saves the file being edited to the specified file
number in the laser marker.
FNM Sets the file name of the number selected.
ME-LPGS-SR-5
Refer
(P.58)
(P.59)
(P.60)
(P.61)
(P.62)
(P.63)
(P.65)
(P.66)
(P.68)
(P.69)
(P.71)
(P.72)
(P.73)
(P.73)
(P.74)
53