Panasonic LP-GS Series Serial Communication Command Manual page 41

5.
When you select "Input all ASCII control codes using
2-byte alternative code" at the input method for
control codes, set the input method of "FNC1".
• ON (Initial setting):
"GS" in the ASCII code 1D (HEX) can be used as "FNC1".
• OFF:
Input 2-byte alternative code (HEX) for "FNC1". The alternative
code is defined by the setting of "Encoding for 2-byte characters" as follows.
Control code
Alternative code (HEX)
Reference
• "FNC1" is used mainly as the separator for the variable-length AI data in the code data of GS1 DataMatrix, GS1 DataBar
codes and EAN-128 (CODE 128).
• When you select "Input EOT/FS/GS/RS/US directly using ASCII code" at the input method for control codes, "FNC1"
should be input with 2-byte alternative code.
• In the readout response data, "FNC1" is always indicated with the 2-byte alternative code.
6.
Click "Set" on the lower right corner of the screen.
The configured items will be reflected to the laser marker.
when Shift JIS is selected
when GB 2312 is selected
ME-LPGS-SR-5
FNC1
F072
AAD3
41