Panasonic LP-GS Series Serial Communication Command Manual page 174

ERROR
CODE
E610 - E613
Marking data are out of range.
E650
E614 - E615 Existed marking data with its Z-position outside
*2 of marking field.
E651 *2 (The LP-GSxxx-L type is excluded.)
Unable to detect the line speed.
E616 *3, *4 Input of the encoder for line speed detection was
wrong.
E617 *3, *4 Unable to follow the line speed.
E618 *3, *4 The marking spacing is too small.
On-the-fly marking is not possible with this
E619 *3, *4 trigger detecting position or lasing start
boundary.
174
Description
ME-LPGS-SR-5
Measures *1
• Check the image display screen and adjust the
data position and size located outside of the
marking field.
• Adjust the X-/Y-axis offset value of the system
offset (system settings screen). (When the
data located outside of the marking field is not
displayed on the image display screen.)
• Adjust the Z-movement of the object group
settings.
• Adjust the Z-movement of the file settings.
• Adjust the Z-axis offset value of the system offset
(system settings screen).
• Confirm the correct input from the encoder to
ENCODER A IN and ENCODER B IN of I/O
terminal.
• When only one phase of the encoder is used,
connect the encoder signal to ENCODER A IN
(X13) and connect ENCODER B IN (X14) to IN
COM. 1 (X2).
• Confirm the encoder input is less than 100kHz per
phase.
• Decrease the line speed.
• Set Lasing start boundary to the upward of the
moving direction.
• Reduce the marking time with the following
measures.
• Increase the scan speed.
• Reduce the spacing between the characters.
• Reduce the character size, etc.
• When Trigger mode is set to Marking at regular
intervals, set the larger value to Marking spacing.
• When Trigger mode is set to Multiple triggers, take
more time for the trigger input intervals.
• Decrease the line speed.
• Set Lasing start boundary to the upward of the
moving direction.
• When Trigger mode is set to Multiple triggers,
check the switch or the sensor connected to
TRIGGER IN of I/O terminal operates properly
without chattering.
• Reduce the marking time with the following
measures.
• Increase the scan speed.
• Reduce the spacing between the characters.
• Reduce the character size.
• Set smaller value to the one-shot pulse
duration of the I/O settings, etc.
• Distance Lasing start boundary from Trigger
detecting position.
• Check the setting value of Workpiece reference
boundary is correct.