Panasonic LP-GS Series Serial Communication Command Manual page 70

Name
(Only with continuous
trigger setting)
Number of scans
Total data length
Reference
• Refer to "Error Indication" (P.169) for error codes details.
• The automatic response data of the error number will not be transmitted in case of errors occurred when the marking
trigger processing is not in progress.
• When on-the-fly marking with multiple triggers or at regular intervals are set, the response data is transmitted at the
timing of each marking completion.
• When the marking interval is too short for transmission time of MST command, MST command is not available. In such
case, check the marking completion by I/O.
⿎ Example of command settings
Condition:
• Setting
• Readout
Condition:
• Response data with
response permitted
Condition:
• Response data with
response permitted
70
Data length
Data contents
[byte]
"0001"–"9999" [times]
4 "0000" : Unknown due to
error occurrence
The data length is fixed.
3
• When the trigger mode is other than "continuous trigger": 3-byte
or
• When the trigger mode is "continuous trigger": 8-byte (Length including the
8
separator ",")
Response setting = 1
Transmission data
Transmission data
Response data
Status = 000 (normal end)
Response data
With continuous trigger setting
Status = 000 (normal end), Number of scans = 5
Response data
• Only when the trigger mode is continuous trigger,
the executed number of scanning operation with
one trigger is returned.
• With "allow to stop halfway" setting when the
marking operation stops halfway because
TRIGGER IN turns OFF, this operation is counted
as one normal scanning.
• If an error other than E630 and E631 occurs and
lasing operation stops, the response data is "0000".
• When the executed number of scans are 9999 or
more, the response data is "9999".
[STX] MST S 1
[STX] MST R [CR]
[STX] MST A 1
[STX] MST A 000
[STX] MST A 000,0005
ME-LPGS-SR-5
Remarks
[CR]
[CR]
[CR]
[CR]