Laser Settings Per 2D Code Pattern: Brp - Panasonic LP-GS Series Serial Communication Command Manual

3-7-4 Laser settings per 2D code pattern: BRP

Sets the laser settings and filling details by each element of the 2D code (QR codes and Data matrix codes).
Reference
• If the object type set in the specified object number is not the bar code/2D code, the laser marker returns the negative
response.
• The settings by this command are not applied to other codes than QR codes, micro QR codes, iQR codes, Data matrix
codes and GS1 Data matrix codes.
⿎ Setting request data / response data for readout
Start
BRP
code command
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
BRP
code
⿎ Data description
Name Omit
Object No.
Code element
[Object No.], [Code element],
Sub [Marking ON/OFF or Custom pattern ON/OFF ],
[Laser power correction], [Scan speed correction]
[Object No.], [Code element]
R
Max. 6-byte
Data length
[byte]
– Max. 4* "0000"–"1999"
QR code:
"1": Quiet zone outline
"2": Dark module
"3": Light module
"4": Alignment
"5": Finder
– 1
Data Matrix code:
"1": Quiet zone outline
"2": Dark module
"3": Light module
"4": Border
Max. 16-byte
(Check sum)
Data contents
ME-LPGS-SR-5
(Check
End code
sum)
End code
Remarks
• For "alignment", "finder", and
"border", the following settings will
be reflected to marking only when
the fill type is "font".
• When the code type is micro QR
code or iQR code, you do not need
to set "alignment".
109