Panasonic LP-GS Series Serial Communication Command Manual page 55

Type Name
Graphic file (VEC format file)
Graphic object settings
(VEC format file)
Point radiation parameters
Object creation
Object deletion
Object marking specification
Object coordinate
Object movement
Object group settings
File settings
Marking position and laser power
adjustment per trigger
External offset settings
External offset values
Step & repeat settings
Step & repeat fine-adjustment
Motion settings for all files *1
Motion settings for current file *1
Code Functions
CDF Sets the graphic file (VEC format) used for the
graphic object.
CDC Sets the parameters such as the position and size
of the graphic object (VEC format file).
PRD Sets the position, time and laser power correction
ratio of the point radiation.
CRE Creates a new object by specifying the object
number, object group to which the object belongs,
and object type.
DEL Deletes a marking object.
ENA Sets whether or not to mark the object of the
specified number or data in the object group.
POS Sets the base position of the marking object.
POR Sets the base position of the marking object using
the relative value from the current position.
GRP Sets the marking position and over-marking by
object group. It is also used to specify the filling
line spacing for bold characters and bar codes.
ALC Adjusts the marking position and layout for each
file. These settings are applied to all marking data
in the selected file.
SEO When the external offset function with "Using
SEO command" is set, this command specifies the
offset value of marking position and laser power
for all marking data in the file. Send this command
per marking trigger.
OFC Sets input methods between I/O or SEO command
for "External Offset Function" to adjust the marking
position and laser power for the entire file data.
OFS Sets offset value of marking position and laser
power for the entire file data used for "External
Offset Function" with I/O input.
SRC Sets the condition of "Step & repeat" to mark the
same marking contents on multiple locations in
one file.
SRA Sets the fine-adjustment of "Step & repeat" to
mark the same marking contents on multiple
locations in one file.
FLY Sets the basic configuration of the on-the-fly
marking, such as moving direction and etc. The
settings are applied to all marking files.
FLF Sets the detailed parameters of on-the-fly marking
for the selected marking file, such as the line
speed, lasing start boundary and etc.
ME-LPGS-SR-5
Refer
(P.113)
(P.114)
(P.116)
(P.120)
(P.121)
(P.122)
(P.123)
(P.124)
(P.125)
(P.127)
(P.128)
(P.131)
(P.132)
(P.134)
(P.136)
(P.142)
(P.143)
55