Command Mode: Rsm - Panasonic LP-GS Series Serial Communication Command Manual

3-15-2 Command mode: RSM

Switches the command mode between LP-400/LP-V compatible mode and the standard one. This command is available
when LP-400/V compatibility setting is enabled in system settings.
⿎ Setting request data / response data for readout
Start
RSM Sub command
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
RSM
code
⿎ Data description
Name Data length [byte]
Command mode
Total data length
Reference
• This command is available only when "LP-400/V compatibility" is enabled in system settings of Laser Marker NAVI
smart.
• When "LP-400/V compatibility" is enabled in system settings of Laser Marker NAVI smart, the command mode is always
"LP-400/V command mode" at the time of starting the remote control mode. To use standard command mode, always
send this command at first or disable "LP-400/V compatibility" in system settings.
• To switch the command mode from "LP-400/V command mode" to "standard command mode" by RSM command, the
communication format (start code, sub-command and etc.) of the setting request data should be followed by LP-400/V
compatible format. The response data to this setting request is returned also in LP-400/V compatible format. The standard
command format is applied afterward.
• The setting by this command is not saved in the laser marker.
⿎ Example of command settings
Condition: Command mode = 1
• Setting
Transmission data
• Readout
Transmission data
Response data
[Command mode]
1-byte
R (Check sum)
"0": LP-400/V command mode
1
"1": Standard command mode
1 The data length is fixed.
[STX] RSM
[STX] RSM
[STX] RSM
(Check sum)
End code
Data contents
S 1 [CR]
R [CR]
A 1 [CR]
ME-LPGS-SR-5
End code
Remarks
155