Panasonic LP-GS Series Serial Communication Command Manual page 139

Reference
• When the adjustment item is set to Mark OFF, the subsequent data after X-movement do not exist in the response data
for readout.
⿎ Setting request data / response data for readout: when adjustment object is rectangle
Start
SRA
code command
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Data description
Name Omit length
[byte]
Adjustment
– Max. 3*
No.
Adjustment
–
object
Object group
– Max. 4*
No.
Start row – Max. 3*
Start column – Max. 3*
Last row – Max. 3*
Last column – Max. 3*
Adjustment
–
item
X-movement Y Max. 8*
Y-movement Y Max. 8*
Z-movement Y Max. 8*
Rotation
Y Max. 8*
movement
Laser power
Y
correction
Total data length Max. 68
* Setting request data are variable length.
[Adjustment No.], [Adjustment object], [Object group No.],
[Start row], [Start column], [Last row], [Last column],
Sub
[Adjustment item], [X-movement], [Y-movement],
[Z-movement], [Rotation movement], [Laser power correction]
Data
Data contents
"000"–"999"
1 "4": Rectangle
"0000"–"1999"
"001"–"400"
"0": Position/Power
1
"1": Mark OFF
"-999.999"–"+999.999" [mm]
Model
LP-GS051 "-003.000"–"+003.000"
LP-GS052 "-001.500"–"+001.500"
LP-GS051-L
LP-RC350S
LP-RF200P
"-180.000"–"+180.000" [°]
3 "-50"–"+50" [+/-%]
It is the length including the separator ",".
Max. 68-byte
Specifies an object group number with
Step & repeat set.
• Enables the adjustment item for the
• The settings that the last row/column
If you specify "1": Mark OFF, end
the data here. It is not necessary to
transmit the subsequent data including a
separator ",".
• Moves the coordinate of the marking
Setting range [mm]
• It is the movement for the coordinate
• Z-movement cannot be specified
"+000.000" or omit
Corrects the laser power of the marking
data in the range of rows/columns
specified.
Specify the correction ratio in the range
of 100±50% relative to the laser power
for the object to which Step & repeat
applies.
ME-LPGS-SR-5
(Check
sum)
Remarks
data at the row/column specified.
comes before the start row/column
are not allowed.
data in the range of rows/columns
specified.
after executing Step & repeat.
with LP-GS051-L, LP-RC and LP-RF
series.
End
code
139