ISSUE 2.0
Description
Automatic Release drops the line circuit when an outside party abandons the call. For this feature to
work with Loop Start Trunks, the CO/PBX providing the outside line must provide a timed disconnect
signal. Automatic Release is normally provided on Ground start trunks are not supported please
remove, DID and ISDN trunks.
Conditions
• Automatic Release on ISDN trunks is provided by the protocol.
• When an outside line is accessed using a dedicated line key, the LED associated with the line key
goes off when Automatic Release occurs.
• On Loop Start trunks Automatic Release is only available on incoming calls.
• This feature functions while a call is in progress, on hold, or in a conference.
• This feature applies to all ICM type calls in progress, holding or parked.
• When Automatic Release occurs and the telephone is in handsfree mode, Speaker automatically
turns off. If using the handset, the station is set to idle when the handset goes on-hook.
Default Settings
None
System Availability
Terminals
Not applicable
Required Component(s)
None
Related Features
Central Office Calls, Answering
Central Office Calls, Placing
Guide to Feature Programming
Program Num-
ber
14-02-09
Analog Trunk Data Setup - Busy Tone Detection
Features and Specifications Manual
Program Name
SL1000/SL1100
Automatic Release
Default
0
A
1-41