Single Line Terminals - NEC SL1000 Features And Specifications Manual

SL1000/SL1100
Description
The system is compatible with Dial Pulse and DTMF analog Single Line Terminals (SLTs). Single Line
Terminal users can dial codes to access many of the features available to Multiline Terminal users.
With Single Line Terminals, you can have your system simulate PBX type operation.
There are 128 (SL1000) 60 (SL1100) Single Line Terminals available (note that this number may be
restricted due to system power requirements).
S
When installing Single Line Terminals you must have:
• A port on a 408M-A1/408E-A1/008E-A1 (SL1000) 084M-B1/008E-B1 (SL1100) for each Single Line
Terminal installed.
• If you have DTMF sets, at least one block reserved on the CPU for analog extension DTMF
reception.
DTMF Dial Out Timer Added
A program is added for DTMF dialing, PRG 20-03-07 : System Options for Single Line Terminals-
Trunk Call Dial Forced Sending Start Time (Forced Dial). When PRG 20-03-03 : System Options for
Single Line Terminals - SLT DTMF Dial to Trunk Lines is set to 0 (receive all digits before sending),
the system follows the timers in PRG 20-03-04 and PRG 20-03-07.
The timer in PRG 20-03-04 System Options for Single Line Terminals - Dial Sending Start Time for
SLT or ARS resets when the user dials another digit.
The timer in PRG 20-03-07 System Options for Single Line Terminals - Trunk Call Dial Forced
Sending Start Time (Forced Dial) does not reset when a digit is dialed. The user must finish dialing all
the digits before this timer expires (entries: 0~64800 seconds, default: 0).
Conditions
• Dial Pulse Single Line Terminals cannot access any feature that requires the user to dial # or
• A Single Line Terminal can initiate an Internal Zone page, but cannot receive an Internal Zone
Page.
• When a Ring Group call rings a single line station, the BLF indication shows busy.
• Stutter Dial Tone is supported to Single Line Terminals for Voice Mail Message Waiting.
• The 1632M KSU has 20 (SL1000) 1228M KSU has 16 (SL1100) resources for DTMF receiving and
Dial Tone detection. When a 1632ME EXP (SL1000) 1228ME EXP (SL1100) with EXIFE-C1 is
installed there are 32 resources available.
• When PRG 10-09-01 is set to 0 (Common) and PRG 14-02-10 (Caller ID) is set to 1 (Yes), all
DTMF/Dial Tone Detection resources are always allocated to analog trunks, not analog extensions.
However, if PRG 14-02-10 (Caller ID) is set to 0 (No), all DTMF/Dial Tone Detection resources can
be used for both analog trunks and analog extensions.
• The Exclusive Hold Recall Timer is used when an internal call from a Single Line telephone or 3rd
party SIP telephone is placed on Hold.
Default Setting
Single Line Terminals function as soon as they are installed and properly programmed.
1-630

Single Line Terminals

ISSUE 2.0
*
.
Single Line Terminals