NEC Aspila Topaz Programming Manual page 11

How to Enter the Programming Mode
Depending on the mode of programming, the system may allow more than one person in the programming
mode at one time. With telephone programming, two people can program simultaneously. Using the PC
Program, only one person is allowed in programming. If the same program number is being defined
simultaneously, the last changes made to the program will be accepted.
To enter the programming mode:
1. Go to any working display
In a newly installed system, use extension 200 (port 1).
2. Do not lift the handset.
3. Press SPK.
4. # * # *
5. Dial the system password + HOLD.
Refer to the following table for the default system passwords. To change the passwords, use Program
90-02.
It is NOT recommended to change these data unnecessarily. The worst case
Caution
may happen is that there is no normal way to go into program mode again, if
the digits entered is forgotten, then.
Password
12345678
0000
9999
How to Exit the Programming Mode
To exit the programming mode:
When you are done programming, you must be out of a program's options to exit (pressing the DC key will
exit the program's option).
1. Press DC key to exit the program's options, if needed.
█
Program Mode
2. Press SPK. You see, "SavingSystemData" if changes to were to the system's programming.
3. The display shows "CompleteDataSave" when completed and will exit the phone to an idle mode.
To save a customer's database, a blank Compact Flash Memory Card is required. Insert the card into
the EXIFU-A1 and, using Program 90-03, save the software to the Compact Flash Memory Card.
(Program 90-04 is used to reload the customer data if necessary.) Note that a Compact Flash Memory
Card can only hold one customer database. Each database to be saved will require its own separate
card.
Introduction to Programming
telephone.
Level
2(IN) All programs in this Manual not listed below for SA and SB
3(SA)
10-01,10-02,10-24,12-02,12-03,12-04,15-01,15-07,15-09,15-10,15-11,
20-16,21-07,21-14,22-04,22-11,25-08,30-03,32-02,40-02,45-02,45-03,
90-03, 90-04,90-06,90-07,90-19
4(SB) 13-04,13-05,13-06
Before You Start Programming
Program at this Level
3
Programming Manual