NEC Aspila Topaz Programming Manual page 386

Program 92: Copy Program
92-01: Copy Command
2. Trunk Group Base
Prog.No.
35-03 SMDR Port Assignment for Trunk Group
3. Extension Base
Prog.No.
Extension Basic Data Setup (include Virtual
15-01
Extension)
15-02 Multi-Line Telephone Basic Data Setup
15-03 Single Line Telephone Basic Data Setup
15-06 Trunk Access Map for Extension
Programmable Function Key
15-07
15-08 Incoming Virtual Extension Ring Tone Setup
15-09 Virtual Extension Ring Assignment
Incoming Virtual Extension Ring Tone Order
15-10
Setup
15-11 Virtual Extension Delayed Ring Assignment
Conversation Recording Destination for
15-12
Extension
20-06 Class of Service for Extension
Trunk Group Routing for Extensions
21-02
21-04 Toll Restriction Class for Extensions
21-11 Hotline Assignment
23-03 Ringing Line Preference
Ringing Line Preference for Virtual
23-04
Extensions
24-03 Park Group Assignment
31-02 Internal Paging Group Assignment
4. Department Group Base
Prog.No.
Department (Extension) Group Basic Data
16-01
Setup
SMDR Port Assignment for Department
35-04
Group
5. DSS Console Base
Prog.No.
30-03 DSS Key Assignment
Conditions
Using this program to copy a keyset's Programmable Function Keys will copy all the keys whether they exist on the
phone to which the programming is being copied. This may cause confusion when trying to define a key which is
already defined but which doesn't exist on the phone (will display as "DUPLICATE DATA"). It is recommend to
either clear these non-existent keys or to only copy from an extension which has the same or fewer number of keys
than the extension to which the programming is being copied.
Programming Manual
Program Name
Program Name
Program Name
Program Name
378
Note
Note
Copy all data except extension name(15-01-01)
Note
Copy all data except Group Name (16-01-01).
Note
IN
SA
SB