NEC Aspila Topaz Programming Manual page 255

IN
Program 26:
SA
SB
Description
Use Program 26-03 : ARS Dial Treatments to assign the 15 Dial Treatments for automatic ARS Dialing
translation. Assign Dial Treatments to Service Numbers (Trunk Groups) in Program 26-02.
The ARS Dial Treatment options are:
• 3 - Delete the NPA if dialed as part of the initial call.
• 2 - Delete the leading digit if dialed as part of the initial call.
• 1 - Add a leading 1 if not dialed as part of the initial call.
• INPA - Insert the NPA specified by NPA.
• DNN - Outdial the NN number of digits or execute the code that follows. For example, D041234 out-dials 1234.
Valid entries are 0-9, #, *, Wnn (wait nn seconds) and P (pause). Each digits code counts as a digit. So for example,
if a P was added for a pause, the entry would look like: D05P1234. This Dial Treatment can only be added from
telephone programming.
• Wnn - Wait nn seconds.
• P - Pause in analogue trunk.
• R - Redial the initially dialed number, including any modifications
• E - End of Dial Treatment. All Dial Treatments must end with the E code.
• X - When ARS is enabled, X must be entered in the Dial Treatment in order for the system to output the extension
number of the call's originator to the black box for the E911 feature.
Input Data
Dial Treatment Table
Prog. No.
Number
26-03-01 1-15
Conditions
None
Feature Cross Reference
Automatic Route Selection
Telephone Programming Instructions
To enter data for Program 26-03(ARS Dial Treatments):
1. Enter the programming mode.
2. Enter 26 03
26-03-01ARS-T1
3. Enter the number of the item you want to program.
26-03-xxARS-Txx
xxxxx
4. Select the Dial Treatment Table number to be programmed by pressing the FLASH or the VOLUME▲ or
VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series's programming section
ARS Service & Least Cost Routing
26-03: ARS Dial Treatment
Input Data
Max. 36 characters
247
Related
Default
Program
No setting 26-02
Programming Manual