NEC Aspila Topaz Programming Manual page 364

Program 90: Maintenance Program
90-05: Slot Control
Description
Use Program 90-05 : Slot Control to close (turn off) or delete (uninstall) circuit boards (slots 1-18).
Delete allows you to completely uninstall the PCB. You might want to do this if you want to remove a PCB and
plug it into a different slot - and still retain the port assignments. If a different type of interface card is being
installed into a slot previously used (example; changing from a BRIU to VOIPU PCB), the slot should be deleted
(Menu 1) first before installing the new interface card.
Reset allows you to send a reset code.
Input Data
Menu Number
Conditions
When you delete or reset a PCB, you must first remove it from its slot then run Program 90-05.
When reusing the slot for another PCB, you must plug the PCB in or reset the system before the system will use the
slot again.
Feature Cross Reference
None
Telephone Programming Instructions
To enter data for Program 90-05 (Slot Control):
1. Enter the programming mode.
2. Enter 90 05
90-05-01 Menu 1
Slot Number
3. Enter the number of the item you want to program.
90-05-xx Menux
xxxxx
4. Select the Menu number to be programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you've exited that series's programming section
Programming Manual
Slot Number
1-18 (0 : No Setting)
356
IN
SA
SB
1 : Delete
2 : Reset