NEC Aspila Topaz Programming Manual page 173

IN
SA
SB
Description
Use Program 21-01 : System Options for Outgoing Calls to set the system options for Outgoing Call Service.
Input Data
Prog. No.
21-01-01 Seizure Trunk Line Mode
21-01-02 Intercom Interdigit Time
When placing
extension users must dial each digit
within this interval.
21-01-03
Trunk Interdigit Time (External)
The system waits for this timer to
expire before placing the call in a talk
state (Call Timer starts after timer
expires, Barge-In are not allowed
until after timer expires).
21-01-04
Researched time for DTD circuit
21-01-05 Dial Tone Detection Time
If dial tone detection is enabled, the
system will wait this interval for the
Telco to return dial tone. When the
interval expires, the system assumes
dial tone is not present. To disable
this timer (and have the system wait
continuously), enter 0.
21-01-06
Dial pause at first digit
21-01-07 Toll Restriction Override Time
After dialing the Toll Restriction
Override codes, the system removes
Toll Restriction from the extension
for this interval.
21-01-08 Preset dial display hold time
21-01-09
Ringdown Extension Timer
A Ringdown extension automatically
calls its programmed destination after
this interval.
21-01-10 Dial Digits for Toll Restriction Path
control
21-01-11 Inter-Digit Time for Toll Restriction
Path control
21-01-12 -Not Used-
21-01-13 -Not Used-
Program 21: Outgoing Call Setup
21-01: System Options for Outgoing Calls
Item
0 : Route to Priority order
1 : Route to circular
0-64800(sec.)
Intercom calls,
0-64800(sec.)
0-64800(sec.)
0-64800(sec.)
0-64800(sec.)
0-64800(sec.)
0-64800(sec.)
0-64800(sec.)
0-36
0-60(sec.)
-
-
165
Input data Default
Programming Manual
Related
Program
14-05
0
14-06
10
10 14-02-08
5
0
3
10
5
5
0
0
-
-