Setting Communications Parameters (Snmp Protocol) - Huawei FusionCol8000-E240 User Manual

FusionCol8000-E240 Modular Indirect Evaporative
Cooling System
User Manual
Parameter
NMS IP
address
NMS port
number
----End

6.4.4.3 Setting Communications Parameters (SNMP Protocol)

Context
●
●
●
●
Procedure
Step 1 On the home screen, choose Settings > Comm Settings > SNMP Settings.
Figure 6-12 Setting SNMP communications parameters
Step 2 Set SNMP Version based on site requirements, and then tap Submit.
●
●
Step 3 Set Read Community and Write Community.
1.
Issue 01 (2021-01-30)
Setting
-
-
To set communications parameters, log in as the admin user.
This section is suitable only for SNMP. Skip this section if you use Modbus.
Record the values entered in this section. They will be used when you access a
smart cooling product to a network management system (NMS).
One smart cooling product supports concurrent access of up to 6 NMSs
through SNMP.
If you set SNMP Version to ALL or SNMPv1&v2c, you can set Read
Community and Write Community by performing
If you set SNMP Version to ALL or SNMPv3, you can add SNMPv3 users by
performing Step 4.
Tap the text box next to Read Community, set the read community
parameter based on the actual plan, tap
Copyright © Huawei Technologies Co., Ltd.
Setting Method
Enter the actual IP address of the NMS. IP
addresses of the display panel, NMS client, and
NMS server must be unique. This parameter is
configurable when Link mode is set to Client.
It is recommended that you retain the default
value. If you need to change the value, enter a
value as required. This parameter is configurable
when Link mode is set to Client.
, and tap Submit.
6 Power-On Commissioning
Step 3.
114