NEC Express5800 Series Maintenance Manual page 139

Chapter 3 Appendix
Error Message
th
C066 6 SMBus device Error
detected.
th
C067 7 SMBus device Error
detected.
th
C068 8 SMBus device Error
detected.
C103
BMC core hardware failure.
C104 BMC IBF or OBF check failed. Accessing the BMC address failed.
C105 BMC SEL area full.
C10C BMC update firmware
corrupted.
C10D Internal Use Area of BMC FRU
corrupted.
C10E
BMC SDR Repository empty.
C10F IPMB signal lines do not
respond.
C110 BMC FRU device failure.
C111 BMC SDR Repository failure.
C112 BMC SEL device failure.
C113 BMC RAM test error.
C114 BMC Fatal hardware error.
C11B BMC Mezzanine card is not
found.
C11C BMC Mezzanine partition is
invalid.
C11E Communication with BMC was
failed in previous boot
C301 SDR mismatch error.
C302 Hardware configuration error. Detected that hardware
C304 Necessary to update SDR
Version for new RAID Card.
C310 Hardware configuration of
cooling is insufficient.
C320 Unmatched PSUs.
C321 System power consumption is
out-of-range in PSUs.
C322 No information for system
power consumption check.
Cause
th
An error occurred in the 6 SM
Bus.
th
An error occurred in the 7 SM
Bus.
th
An error occurred in the 8 SM
Bus.
BMC device (chip) error was
detected.
There is not enough capacity to
write the system event log.
BMC device (chip) error was
detected.
Failure of the SROM for storing
chassis information was detected.
BMC device (chip) error was
detected.
SMC (Satellite Management
Controller) failure was detected.
Failure of the SROM for storing
chassis information was detected.
Failure of the SROM for storing
sensor data record information was
detected.
BMC device (chip) error was
detected.
BMC RAM error was detected.
BMC error was detected.
BMC Mezzanine card is not
mounted.
BMC Mezzanine partition is invalid.
Communication with BMC failed in
previous boot
Inconsistency in the hardware
information of the sensor data
record was detected.
configuration of the server is illegal.
SDR version is not appropriate to
the RAID Controller.
Detected that cooling power is
insufficient in this hardware
configuration.
Detected that unmatched power
supply units are configured.
Detected that system power
consumption exceeds the power
output capacity limit.
Detected that no information was
acquired in checking system power
consumption.
Express5800/B120e-h Maintenance Guide
1. POST Error Message
Solution
Contact your sales representative.
Turn off the power, wait for about 30
seconds, and restart the server. If this does
not resolve the problem, contact your sales
representative.
Start up the Offline Tools and delete the
event logs.
Turn off the power, wait for about 30
seconds, and restart the server. If this does
not resolve the problem, contact your sales
representative.
Turn off the power, wait for about 30
seconds, and restart the server. If this does
not resolve the problem, contact your sales
representative.
Turn off the power, wait for about 30
seconds, and restart the server. If this does
not resolve the problem, contact your sales
representative.
Contact your sales representative.
Unplug the power cord, wait for about 30
seconds, and restart the server. If the same
error persists, contact your sales
representative.
Contact your sales representative.
(6/7)
139