Startup And Exit Of System Diagnostics - NEC Express5800 Series Maintenance Manual

Chapter 1 Maintenance
8.2

Startup and Exit of System Diagnostics

Start up System Diagnostics in the following procedure. (If the server is running, shutdown the system.)
1. Start up EXPRESSBUILDER and select Tool menu from Boot menu.
For information on starting up EXPRESSBUILDER, refer to Chapter 2 (5. Details of
EXPRESSBUILDER).
2. Select Test and diagnostics.
3. Select End-User Mode (Basic) to start System Diagnostics. This process takes about three
minutes.
When the diagnostics is completed, the screen changes as shown below.
See eupro_ug_en.pdf in the \isolinux\diag folder of EXPRESSBUILDER for the End-User
Mode (Professional) feature.
Diagnostics tool title
Diagnostics tool title
Shows the name and version of the diagnostic tool.
Test window title
Shows the progress of the diagnostics. "Test End" is displayed when the diagnostics completes.
Test results
Shows the start, end, and elapsed time and completion status of the diagnostics.
Guideline
Shows the details of the keys to operate window.
Test summary window
Shows the results of each test. Move the cursor and press <Enter> key on the cursor line to
display the details of the test.
When an error is detected by System Diagnostics, the relevant test result in the Test summary
50
Note In case Language selection menu appears, select English.
If " Hit key to continue. [y|Y] " is displayed in Redirection mode, press <y> key (or <Y>
key).
Guideline
Express5800/B120e-h Maintenance Guide
8. System Diagnostics
Test window title
Test results
Test summary
window