NEC Express5800 Series Maintenance Manual page 85

Chapter 2 Convenient Features
Option
Thermal Sensor
Check previous System
Config
BMC IRQ
Post Error Pause
Memory Error
Power Switch Inhibit
CLI SETUP
Parameter
Disabled
Enable or disable the thermal sensor monitoring feature.
[Enabled]
If this option is set to Enabled and when abnormal temperature is
detected, the POST stops before starting an OS, and waits until
the temperature becomes normal.
[Disabled]
Enable or disable the feature to detect system configuration
Enabled
change.
If this option is set to Enabled and the system configuration
differs from the previous boot, the system stops before OS
booting and displays confirmation message whether to continue
booting. At this time, POST pauses until user's response is made.
[Disabled]
Specify whether to allocate interrupt lines for BMC (Baseboard
[RQ 11]
Management Controller).
Disabled
Enable or disable the feature to suppress OS booting when
[Enabled]
POST detects an error, until user's response is made.
When set to Disabled, continues OS booting regardless of user's
response even if an error is detected during POST.
Halt
Enable or disable the feature to suppress OS boot process until
[Boot]
user interruption occurs when POST detects degration error
occurred on memory resources. This feature is enabled if POST
Error Pause is set to Enabled.
Even if this option is set to Boot, OS boot process stops at the
end of POST if errors occurred for all memory resources.
[Disabled]
Enable or disable the power switch inhibit feature.
Enabled
[Disabled]
Enabale or disable the Command Line Interface SETUP feature.
Enabled
When this option is set to Enabled, the BIOS Setup utility is run
by the CLI SETUP (Command Line Interface SETUP Menu)
instead of the MENU SETUP. To switch back to the MENU
SETUP, set this option to Disabled in the CLI SETUP menu.
Express5800/B120e-h Maintenance Guide
1. System BIOS
Descriptions
[ ]: Factory settings
85