Brother DCP-340CW Network User's Manual page 138

Wireless installation for Macintosh
9
For configuration, it is recommended that you
temporarily connect your Brother wireless device
directly to a free port on your access point, hub or
router using a network cable.
If you can temporarily connect with a network cable:
Choose I'm able to temporarily connect my
device to my access point with a network cable
and then click Next.
Go to step 10.
If you do not have a network cable or cannot
temporarily connect the Brother wireless device to
your access point:
Choose I'm not able to connect my device to my
access point with a network cable and then click
Next.
Go to step 11.
10
Read the Important Notice.
For DCP-340CW: Press Menu,
6, and choose Wired LAN. Press Menu. If Reboot
OK? is displayed, press
network interface will become inactive with this
setting. The machine will restart automatically. After
it restarts, check the box on the screen and click
Next.
For MFC-640CW: Press Menu/Set, 5, 6, and then
press ▲ or ▼ to choose Wired LAN. Press
Menu/Set. If Reboot OK? is displayed, press
1.Yes. The wireless network interface will become
inactive with this setting. The machine will restart
automatically. After it restarts, check the box on the
screen and click Next.
For MFC-820CW: Press Menu on the control panel. Press
for Network I/F and press OK. Press
displayed, press 1 for Yes. The wireless network interface will become inactive with this setting. The
machine will restart automatically. After it restarts, check the box on the screen and click Next.
If Accepted is displayed, press Stop/Exit. Check the box and click Next.
Note
It will take approximately one minute for the LAN menu on the LCD to become available after the machine
restarts or is turned on.
®
or to choose 3,
▲ ▼
▲ for Yes. The wireless
or
▲ ▼
for LAN and press OK. Press
or
▲ ▼
for Wired LAN and press OK. If Reboot OK? is
9
or
▲ ▼
9 - 16