Brother DCP-340CW Network User's Manual page 86

Wireless installation for Windows
9
Read the Important Notice.
For DCP-340CW: Press Menu,
6, and choose Wired LAN. Press Menu. If Reboot
OK? is displayed, press
network interface will become inactive with this
setting. The machine will restart automatically. After
it restarts, check the box on the screen and click
Next.
For MFC-640CW: Press Menu/Set, 5, 6, and then
press ▲ or ▼ to choose Wired LAN. Press
Menu/Set. If Reboot OK? is displayed, press
1.Yes. The wireless network interface will become
inactive with this setting. The machine will restart
automatically. After it restarts, check the box on the
screen and click Next.
For MFC-820CW: Press Menu on the control panel. Press
for Network I/F and press OK. Press
displayed, press 1 for Yes. The wireless network interface will become inactive with this setting. The
machine will restart automatically. After it restarts, check the box on the screen and click Next.
If Accepted is displayed, press Stop/Exit. Check the box and click Next.
Note
It will take approximately one minute for the LAN menu on the LCD to become available after the machine
restarts or is turned on.
For configuration, you must temporarily connect
your Brother wireless device directly to a free port on
your access point, hub or router using a network
cable.
When the following screen appears, open the
scanner cover to its open position. Insert the network
cable to the access point and then to the machine.
You will find the LAN socket above and to the left of
the ink cartridge slots, as shown. Click Next and go
to step 13.
®
▲ or ▼ to choose 3,
▲ for Yes. The wireless
▲ or ▼
for LAN and press OK. Press
▲ or ▼
for Wired LAN and press OK. If Reboot OK? is
8
▲ or ▼
8 - 4