Control panel setup
5
to select Change.
Press
▲
or
▼
Press OK.
6
Enter the Gateway address.
Press OK.
7
Press Stop/Exit.
5.Node Name
You can register the machine name on the Network. This name is often referred to as a NetBIOS name; it will
be the name that is registered by the WINS server on your network. Brother recommends the name
BRN_xxxxxx for a wired network or BRW_xxxxxx for a wireless network (where XXXXXX is the last six digits
of the Ethernet address) (up to 15 characters).
(For DCP-340CW)
1
Press Menu.
2
Press
▲
or
▼
to select 3.LAN.
Press Set.
3
(For Wired) Press
▲
(For Wireless) Press
Press Set.
4
Press
▲
or
▼
to select 5.Node Name.
Press Set.
5
Press
▲
or
▼
to select 1 to change.
Press Set.
6
The Node Name will be displayed.
7
Press Stop/Exit.
Note
DCP-340CW cannot change the Node Name from the control panel menu, however the BRAdmin
Professional utility enables you to change the IP address. See Using the BRAdmin Professional utility to
change the print server settings (for Windows
or
to select 1.TCP/IP(Wired).
▼
▲
or
▼
to select 2.TCP/IP(WLAN).
®
only) on page 2-5.
4
4 - 9