Control panel setup
6
Press Stop/Exit.
(For MFC-640CW)
1
(For Wired) Press Menu/Set, 5, 1, 1.
(For Wireless) Press Menu/Set, 5, 2, 1.
2
Press
▲
or
▼
to select Auto, Static, RARP, BOOTP or DHCP.
3
Press Menu/Set.
4
Press Stop/Exit.
(For MFC-820CW)
1
Press Menu.
2
to select LAN.
Press
▲
or
▼
Press OK.
3
(For Wired) Press
▲
(For Wireless) Press
Press OK.
4
Press
or
to select BOOT Method.
▲
▼
Press OK.
5
Press
▲
or
▼
to select Auto, Static, RARP, BOOTP or DHCP.
Press OK.
6
Press Stop/Exit.
Auto mode
In this mode, the machine will scan the network for a DHCP server, if it can find one, and if the DHCP server
is configured to allocate an IP address to the machine, then the IP address supplied by the DHCP server will
be used. If no DHCP server is available, then the machine will scan for a BOOTP server. If a BOOTP server
is available, and it is configured correctly, the machine will take its IP address from the BOOTP server. If a
BOOTP server is not available, the machine will scan for a RARP server. If a RARP server also does not
answer, the IP Address is scanned through APIPA facility, see Using APIPA to configure the IP address on
page A-3. After it is initially powered ON, it may take a few minutes for the machine to scan the network for
a server.
to select TCP/IP(Wired).
or
▼
to select TCP/IP(WLAN)
or
▲
▼
4
4 - 2