Restoring The Network Settings To Factory Default - Brother DCP-340CW Network User's Manual

Control panel setup
(For MFC-820CW)
1
Press Menu.
2
to select Print Reports.
Press ▲ or ▼
Press OK.
3
to select Network Config.
Press or
▲ ▼
Press OK.
4
Press Mono Start or Colour Start.

Restoring the network settings to factory default

If you wish to reset the print server back to its default factory settings (resetting all information such as the
password and IP address information), please follow these steps:
Note
This function restores all wired and wireless network settings to the factory default.
(For DCP-340CW)
1
Make sure the machine is not operating, then disconnect all the cables from the machine (except power
cable).
2
Press Menu.
3
Press or to select 3.LAN.
▲ ▼
Press Set.
4
Press ▲ or ▼ to select 0.Factory Reset.
Press Set.
5
Press ▲ to select Reset.
6
Press ▲ again to select Yes.
7
The machine will re-start, re-connect cables once this is complete.
4
4 - 28