NEC Express5800/B120b User Manual page 140

5-4 Installing the Operating System with Express Setup
Supported Options by NEC EXPRESSBUILDER
The NEC EXPRESSBUILDER DVD attached to your system supports the following options for
installation.
NOTE: If you want to install the other boards by using a driver floppy
disk ("OEM-FD for Mass storage device"), except ones listed below,
see "Installing with the OEM-FD for Mass storage device" and
"Installing Optional Mass Storage Driver" of "Parameter File Creator"
in Chapter 6.
Options supporting installation of OS with Express Setup
– N8403-026 (RAID Controller)
– N8403-027 (SATA Interface card)
– N8403-018 Fibre Channel Controller
– Storage and I/O Blade AD106a
Other options
– N8403-018 Fibre Channel Controller
– Storage and I/O Blade AD106a
NOTES:
The driver of option card mentioned above is stored in the NEC
EXPRESSBUILDER DVD.
If you use the board not mentioned above, the Express Setup will
fail. Refer to the instructions attached to the board.
About the Hardware Components
When you install the Windows Server 2008, Express Setup requires several preparations if this
computer uses the following hardware components.
Installing on the Mirrored Volume
When re-installing the OS to a hard disk drive which has been upgraded to Dynamic Disk, only the
simple dynamic volume is available for installation.
If you want to install the OS on a volume that is mirrored using Disk Management, invalidate the
mirroring and reset to the basic disk before the installation, and validate the mirroring again after the
installation.
You can create, invalidate, or delete the mirror volume by using Disk Management in Computer
Management.