Table of Contents
Advertisement
8-14 Troubleshooting
Is the system used in the status that Windows Server 2003 and Linux are not started?
→ In the following states with the use of USB keyboard and USB floppy disk drive,
conduct key entries when the access lamp on the USB floppy disk drive is off (or
the floppy disk is not accessed).
– Press F6, S, and Enter in installation by using the Windows Setup Disk.
– Start of ROM-DOS Startup FD for command input
Fail to access the hard disk drive:
(Refer to the documentation provided with the disk array controller for the hard disk drive in disk
array configuration.)
Is the hard disk drive applicable to the CPU blade?
→ Operation of any device that is not authorized by NEC is not guaranteed.
Is the hard disk drive properly installed?
→ Securely insert the drive carrier into the Blade Enclosure and lock it with the lever.
The hard disk drive is not connected to the internal connector when it is not
completely installed (see Chapter 3).
Inserted the correct CD-ROM but the message like the following is displayed:
The CD-ROM is not inserted or the wrong CD-ROM is inserted.
Is the data side of the CD-ROM dirty or damaged?
→ Take the CD-ROM out of the optical disk drive, confirm that it is not dirty or
damaged, reset and click [OK].
Fail to access to the DVD/CD-ROM:
Is the DVD/CD-ROM properly set in the optical disk drive tray?
→ Take the disc out of the tray, and set the disc with its label side upward.
Is the DVD/CD-ROM applicable to the server?
→ The DVD/CD-ROM for Macintosh is not available for use.
→ For the disk which does not conform to the CD standard, the playback of such a
disk with the DVD drive is not guaranteed.
Fail to install the OS:
Did you create virtual disk?
→ Create virtual disks by using WebBIOS.
Please insert the correct CD-ROM.
OK
Advertisement
Table of Contents
