Table of Contents
Advertisement
5-6 Installing the Operating System with Express Setup
Case of using RAID Controller
When you install Windows Server 2008 32bit (x86) Edition by Express Setup after RAID is newly
constructed, the following message may be displayed.
When the message is displayed, refer to following procedure and create RAID beforehand.
Creating RAID manually
Refer to [RAID Configuration (Chapter 4)].
Creating RAID using EXPRESSBUILDER
See "Creating new RAID using RAID Controller (Page 5-56)".
SAN Boot/Storage and I/O Blade AD106a Boot
If you use SAN Boot/Storage and I/O Blade AD106a Boot, confirm BIOS Setup before setup
Windows.
If you use N8403-027, set following BIOS setting.
[Advanced] → [Peripheral Configuration] → [SATA AHCI] and [SATA RAID] change to
[Disabled].
If you use N8403-026, set following BIOS setting.
[Advanced] → [PCI Configuration] → Option ROM Scan [Enabled] → [Disabled]
IMPORTANT: After executing [Load Setup Defaults], set this BIOS
setting. If you do not set up BIOS setting, you could not install
Windows.
Advertisement
Table of Contents
