Table of Contents
Advertisement
11.
From top of the CPU blade, insert the interface card straight into the slot.
IMPORTANT:
Do not make your body contact with the terminals on the card.
Some malfunction may occur if the card is installed with dirt and/or
oil adhering to the terminals.
Insert the interface card straight into the connector. The terminal or
connector may be damaged if it is inclined.
If the card cannot be installed securely, remove the card once and
then install it again. Adding excess force to the card may cause the
card to be damaged.
12.
Push the connector of the interface card with fingers firmly toward the CPU blade to
connect the card to the slot.
13.
Tighten the four fixing screws to fix the interface card to the CPU blade.
14.
Install the components having been removed.
15.
Install the CPU blade having been removed to the Blade Enclosure according to the User's
Guide of the Blade Enclosure.
16.
Turn on the power of the CPU blade. Make sure that any error messages associated with
the card do not appear on the POST screen.
See Chapter 8 for details of POST error messages.
17.
Select [Advanced] – [Reset Configuration Data] and set it to [Yes].
This is required to update the hardware configuration information. See Chapter 4 for
details.
18.
Run the BIOS configuration utility of the installed card to provide setup for the card.
The existence of the utility and its start and operation procedures vary depending on the
type of the card. Refer to the documentation coming with the card for details.
Upgrading Your Server 9-29
Advertisement
Table of Contents
