Table of Contents
Advertisement
4-38 Configuring Your Server
Others
1.
Clear Configuration
Clears configuration information. Select [Configure] → [Clear Configuration] from the
TOP menu. Executing [Clear Configuration] clears all configuration information on the
RAID controller and hard disk drives. The configuration information on all channels of
the RAID controller is also cleared.
NOTES:
LSI Software RAID Configuration Utility cannot delete each virtual
drive. Use Universal RAID Utility instead.
If the configuration information stored in RAID controller differs
from that in hard disk drive, configuration by using the
configuration information in RAID controller will fail. Perform
"Clear Configuration", then create a configuration again.
2.
Force Online
Puts a hard disk drive being in the FAIL status online.
Select [Objects] → [Physical Drive] → (select hard disk drive) → [Force Online] from the
TOP menu.
3.
Rebuild Rate
Sets the Rebuild Rate.
Select [Objects] → [Adapter] → [Sel. Adapter] → [Rebuild Rate] from the TOP menu.
Available value is between 0% and 100%. Default value (recommended) is 30%.
4.
Hard disk drive information
Checks hard disk drive information.
Select [Objects] → [Physical Drive] → (select hard disk drive) → [View Drive
Information] from the TOP menu.
Advertisement
Table of Contents
