Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual page 147

2.
Trigger setting:
Select "Digital CH1" for the "Trigger data" column.
Select "Rise" for the "Trigger type" column.
Select "90"% for the "Trigger position" column.
3.
Measurement will start by clicking [
4.
Measurement automatically starts if the trigger conditions are met (rise of the terminal RUN signal).
5.
Measurement is finished by clicking [
6.
The graph display can be adjusted.
7.
Data can be saved to a file by "Save as" (refer to
NOTE
• In this example, "Trigger position" is set to "90%". After clicking [
and measurement will not start until 90% of the sampling time elapses.
146
3. FUNCTION
3.4 Graph
Start].
Stop], or when the set sampling time is elapsed.
Move up/down the waveform.
page
Select "Digital CH 1".
Select "Rise".
Select "90".
Select " Start".
Select " Stop".
Moves up/down the
digital waveform.
Changes the displayed
position of the vertical
axis scale.
93).
Start], the rise of the terminal RUN signal will be ignored