Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual page 194

 Selecting interface
A
Symbol Name
A USB
B Ethernet
C Select adapter
D Scan network
E Network information
 Select Ethernet Adapter window
Select the network adapter to which the personal computer and inverter are connected.
Symbol Name
A Select Ethernet Adapter Only the adapters connected to the network are displayed.
 Scan Network window
• The inverters connected to the personal computer are detected in the IP address range specified in the "Scan Network"
window.
• The inverter reset time and communication check time interval after firmware update can be set.
Symbol Name
A Search address
B Time setting
NOTE
• To update the firmware of inverters having addresses in different networks, set the default gateway address of the personal
computer and Pr.442 to Pr.445 Default gateway address of the FR-E800 inverters.
• To search the inverters in different networks, configure networks using a router. Up to 512 inverters can be searched.
B
Detects the inverters connected to the personal computer using the USB connector. This
interface is initially selected.
Detects the inverters connected to the personal computer using the Ethernet connector.
Enabled when Ethernet is selected. "Select Ethernet Adapter" window appears.
Enabled when Ethernet is selected. "Scan Network" window appears.
Enabled when Ethernet is selected. Shows the settings set in "Select Ethernet Adapter" and
"Scan Network" windows.
A
A
B
• Search for VFDs in the same network
The inverters are searched in the IP address range of the personal computer.
• Search for VFDs in different networks
The inverters are searched in the specified IP address range.
• Waittime for VFD reset
Set the delay time from when the firmware update is complete until inverter reset
is performed.
• Timeout
Set the communication check time interval for communication with the inverters.
C
D
Function/description
Function/description
Function/description
1
2
E
3
4
5
6
7
8
9
10
193
3. FUNCTION
3.14 Firmware update