Mitsubishi Electric MELSOFT FR Configurator2 Instruction Manual page 148

 Measurement with a trigger
 Trigger data: Fault
1.
Specify the station number to be measured as the "Tgt. St." (Target station). Next, select "Output frequency" for the
"Analog 1" column of "Wave", "RUN" for "Digital 1", and "FU" for "Digital 2".
2.
Trigger setting:
Select "Fault" for the "Trigger data" column.
Select "90"% for the "Trigger position" column.
3.
Measurement will start by clicking [
4.
Operation starts automatically if an inverter alarm occurs.
5.
Measurement is finished by clicking [
6.
The graph display can be adjusted.
Select "FU".
Start].
Stop], or when the set sampling time is elapsed.
Move up/down the waveform.
Select the station to be measured.
Select "Output frequency".
Select "RUN".
Select "Fault".
Select "90".
Select " Start".
Select " Stop".
Moves up/down the
digital waveform.
Changes the displayed
position of the vertical
axis scale.
1
2
3
4
5
6
7
8
9
10
147
3. FUNCTION
3.4 Graph