Mitsubishi Electric MELSEC iQ-R Series User Manual page 104

USB boot mode
This mode boots data from a USB device connected to a USB connector when recovering Windows.
The following shows the procedure for starting the USB boot mode.
1.
Turn the power of this product OFF.
2.
Connect a USB device to boot from to any of the USB connectors (P1 to P4) of this product.
To recover Windows, connect the following devices:
• A USB memory where a recovery drive is created
• A memory device where a system image is created
When starting the USB boot mode without connecting these devices, follow the procedure from the beginning.
3.
Hold the BUS RESET/Y STOP/Y OUT switch on the BUS RESET position to turn the power of this product ON.
This product starts in the USB boot mode.
In the USB boot mode, the READY LED and INFORMATION LED turn ON.
• READY LED: ON (orange)
• INFORMATION LED: ON (green)
• To recover Windows, a USB memory where a recovery drive is created is required in advance. In addition, a
memory device (such as HDD) where a system image is created must be connected to this product.
(Page 99 Creating recovery data)
• When the USB boot mode is started at the same time as the maintenance mode, the maintenance mode
takes priority to start. (Page 26 Operation mode)
■Start priority
The following table shows the start priority on USB boot.
Boot order When starting the USB boot mode
1 "USB1" (USB P1)
2 "USB2" (USB P2)
3 "USB3" (USB P3)
4 "USB4" (USB P4)
5 "SATA2(CFast2)" (Secondary CFast card slot)
6 "SATA1(CFast1)" (Primary CFast card slot)
*1 The boot order can be changed in BIOS.
9 MAINTENANCE AND INSPECTION
102
9.4 Windows Recovery
*1
When starting normally
"SATA1(CFast1)" (Primary CFast card slot)
"USB1" (USB P1)
"USB2" (USB P2)
"USB3" (USB P3)
"USB4" (USB P4)
"SATA2(CFast2)" (Secondary CFast card slot)