Bios Setup; Starting The Setup; Setup Menus - Mitsubishi Electric MELSEC iQ-R Series User Manual

9.3

BIOS Setup

This section explains the setup procedure for BIOS and the menus to be displayed.
Precautions
• Do not change the factory default settings except for the date and time. Note that the operation when settings other than
the date and time are changed is not verified by Mitsubishi Electric. When changing any settings other than the date and
time, confirm that there is no problem with the operation before use.
• Misconfiguration in the BIOS setup causes a serious trouble such as that a system does not start or operate normally. Pay
close attention when changing BIOS settings.
• Ensure that this product and a display are connected before setting up BIOS. No screens appear on a display if connecting
this product and the display after starting the BIOS setup. In this case, turn the power of this product OFF and ON again.
• The BIOS setup settings are recorded in the built-in flash memory. If the power supply from the battery stops, the setting
values are reset to the initial values.
*1 If any problems occur due to changes in the BIOS settings, execute "Restore Default" in "Save & Exit" to initialize the settings.

Starting the setup

After turning the power of this product ON, a splash screen is displayed until the operating system is booted.
The BIOS setup starts by pressing the  or  key while the splash screen is displayed.
The time displayed in a splash screen can be changed in "Setup Pre-Delay" in "System Configuration." Set
the time within the range of 0 to 10 seconds.

Setup menus

The following explains the menus displayed in the setup screen.
Main
The current date and time and the device information are displayed.
Item
BIOS Version
Build Date and Time
(Processor name)
CPUID
Microcode Revision
Total Memory
Memory Speed
System Date
System Time
9 MAINTENANCE AND INSPECTION
92
9.3 BIOS Setup
*1
Description
The version of BIOS is displayed.
The date and time when BIOS was built is displayed.
The name of a processor is displayed.
The CPUID of a processor is displayed.
The revision of microcode is displayed.
The capacity of the installed memory is displayed.
The operating frequency of the installed memory is displayed.
The current date (day of the week/month/day/year) is displayed. (Initial value: Thu 04/01/2021)
To change the date, move the cursor with the  key and enter a date with the number keys or with the , ,
and  keys.
The current time (hour:minute:second) is displayed. (Initial value: 00:00:00)
To change the time, move the cursor with the  key and enter a time with the number keys or with the , ,
and  keys.