Appendix 7 Parameter List; System Parameter - Mitsubishi Electric MELSEC iQ-R Series User Manual

Appendix 7
This section shows the list of parameters.

System parameter

The list of system parameters is shown below.
Item
I/O Assignment Base/Power/Extension Cable Setting
I/O Assignment Setting
Setting of Points Occupied by Empty Slot
Multiple CPU Setting Setting for Number of CPU Modules
Communication Setting between
CPUs
Fixed Scan Communication Setting
Operation Mode Setting
Other PLC Control Module Setting
Inter-module Synchronization Use Inter-module Synchronization Function in System
Setting
Select Inter-module Synchronization Target Module
Fixed Scan Interval Setting of Inter-module Synchronization
Inter-module Synchronization Master Setting
The system parameters must be unified in all CPUs that use the fixed scan communication function and the
inter-module synchronization function.
The CPUs, in which "Not Use" is selected for the fixed scan communication function or inter-module
synchronization function, are not regarded as the same system parameters. Set the same system parameter
settings in all CPUs in the multiple CPU configuration.
Parameter List
Setting of base/power supply module/extension cable
Number of slots
Setting of type/number of points/start XY/module status
Module Name
Control PLC Settings
Refresh Setting
CPU Buffer Memory Setting (when refresh END)
CPU Buffer Memory Setting (when refresh I45 is executed)
PLC Unit Data
Fixed Scan Communication Function
Fixed Scan Communication Area Setting
Fixed Scan Interval Setting of Fixed Scan Communication
Fixed Scan Communication Function and Inter-module
Synchronization Function
Stop Setting
Synchronous Startup Setting
I/O Setting Outside Group
Parameter No.
0203H
0201H
0200H
0203H
0202H
0100H
0301H
0303H
0304H
0308H
0309H

0307H
0306H
0306H
0302H
030AH
0305H

0101H
0101H
0102H
APPX
289

Appendix 7 Parameter List

A