4.5
Writing Parameters to this Product
This section shows the procedure for writing the set parameters to this product.
Operating procedure
1.
Select [Online] [Write to PLC].
2.
Select "System Parameter/CPU Parameter" and "Module Parameter."
3.
Click the [Execute] button.
Parameters are written to this product.
4.
Click the [Close] button.
• The following parameters must be written: system parameters and CPU parameters to operate this product,
and module parameters and module extended parameters to use an I/O module or an intelligent function
module.
• If a new parameter is set or any parameters are changed, reset this product.
4.6
Applying Parameters
This section shows the procedure for applying parameters to this product.
Parameters are applied at the following timing. (Page 57 POWER OFF AND RESET)
• Turning the power of this product OFF and ON
• Resetting the hardware
• Resetting the bus
4 PROCEDURES BEFORE OPERATION
54
4.5 Writing Parameters to this Product