Setting Procedure; Considerations - Mitsubishi Electric MELSEC iQ-R Series User Manual

Setting procedure

The setting procedure for a MELSEC-Q series module in CW Configurator is shown below.
• When CW Configurator can be connected to the actual system configuration, the configuration can be read
by selecting [Online]  [Read Module Configuration from PLC]. For modules of which configuration cannot
be read, drag each module from the "Element Selection" window and drop it onto the "Module
Configuration" window.
• To change "Points," "Start XY," "Control PLC Settings," or "CPU Module Operation Setting at Error
Detected," set the parameters in "System Parameter."

Considerations

The modules requiring particular attentions are shown below.
For details, refer to the manual of each module.
AnyWireASLINK master module and AnyWire DB A20 master module
When AnyWire DB A20 master module is used, select the following model displayed on the "Module Configuration."
Module name
QJ51AW12D2
Q series large type extension base unit (AnS series size)
Select the module which can be mounted on the actual each extension base unit in the "Module Configuration." When a Q
series large type blank cover is used, select the module mounted on the Q series large type blank cover.
APPX
292
Appendix 8 How to Use MELSEC-Q Series Modules
1.
Create a module configuration diagram according to the
actual configuration by dragging each MELSEC-Q
series module from the "Element Selection" window and
dropping it onto the "Module Configuration" window.
2.
Set the parameters of each module.
Model name displayed on CW Configurator
MELSEC_Partner