Advertisement
Communications (Serial and Parallel)
16.2
Communication Settings
4413.Numerical Calculation
Select whether or not to output the results of numerical calculation in the
case that When handshaking is being performed.
If you want to output numerical calculation data, select 8−bit, 16−bit, or
32−bit as the output data length from the Numerical Calculation menu.
Refer to 13.3 Numerical Calculation for details.
4414.Judgment
Select whether or not to output judgment results in the case that When
handshaking is being performed.
Note
If you will use handshaking, it is not possible to set both "4413.
Numerical Calc." and "4414. Output" for no output. One of the
two must be set for output.
442. Reset Cond.
Select one of the following three methods for resetting the parallel
output data.
Latch (factory setting):
Off after image capture:
Off before image capture: Reset (OFF) before starting the next
For a detailed timing chart, refer to Data Switching Timing
443. Setting Template
Set whether or not to re−register the Smart Matching template using
parallel input, and select one of the following four execution methods.
No:
Setting position:
Execution position: Execute the matching checker, and
Adjustment position: Execute the Position Adjustment checker, and
Refer to 16.8 Template (Smart Matching) Re−registration for details.
16 − 14
(page 16 − 27).
Do not re−register, even if the re−register
signal is input.
Execute re−registration at the position that
the template area was set.
re−register at the detected position
(or the position with the highest correlation in
the case that multiple objects are detected).
perform re−registration at the position where the
template area was first set within the corrected
search area.
Hold until output of the next inspection result.
Reset (switch off) after completion of the next
inspection image capture.
inspection image capture (after detecting the
start signal).
OCR Type A230
Advertisement
