Advertisement
Inspection Procedure
OCR Type A230
4.8
Specifying Position and Rotation Adjustment Group
4.8
Specifying Position and Rotation Adjustment Group
Sets the active position and rotation adjustment number within the product type. Only
pre−set position and rotation adjuster can be set here. The corresponding position and
rotation adjuster pattern is displayed brightly during number selection.
When changing the group number of a checker to which rotation adjustment has been
applied, or when changing the adjuster group which has an angle of rotation, an "Area
will be changed. OK?" message is displayed. Select Yes to change the group number.
The execution position (angle) of the checker adjusted for position or rotation will
change at that point.
If you select No, the group number will not change.
If the position and rotation adjustment group is specified before setting an area, then
when setting the area, the image is displayed according to the rotation angle, enabling
the area to be set at the required position.
If the position and rotation adjustment group is specified after setting an area, the
execution position of the checker may change according to the amount of adjustment
requiring the area to be set again.
4 − 22
Advertisement
