Advertisement
OCR Type A230
Re−registration using serial input
Template No.
/IN1 to /IN2
Ready signal
/READY
ON
Template
/IN8
OFF
re−registration
input
In the case of Thru display, image capture is
performed first. After this, the checker is executed
(execution position: smart matching, adjustment
position: position adjustment), and then the re−regis-
tration area is displayed. In the case of Binary dis-
play, the display is temporarily switched to gray.
(A): When READY is on, input the template number on IN1 to IN2.
(B): When READY is on, input IN8.
(C): READY goes off, and the template image re−registration area is displayed.
The re−registration area is decided at this point. If an error occurs (*1), processing
is cancelled and an ERROR signal is output.
(D): While READY is off, re−input IN8.
(E): After the template image re−registration area disappears, the template image is
updated, and the READY signal goes on.
(*1) Typical causes of an error occurring at this point:
− You specified a non−existent checker.
− The specified checker number is set for an image from a camera other than that
set for the capture camera.
− When re−registration is specified at the execution position, the result of number
of detected objects from execution of the smart matching checker was 0.
− When re−registration is specified at the adjustment position, execution of
position adjustment resulted in part of the template area protruding off the
screen.
16.8 Template (Smart matching) Re−registration
(A)
OFF
(C)
(B)
ON
ON
Communications (Serial and Parallel)
(E)
(D)
Re−registration processing
performed.
16 − 45
Advertisement
