Huawei FusionModule500 Smart User Manual page 130

FusionModule500 Smart Mini Data Center
User Manual (Philippines, FusionModule500-
SU61A12S)
Figure 5-6 DIP switch definitions for T/H sensors
Table 5-8 Setting device addresses
Address
1
2
Step 2 Add a T/H sensor.
1.
2.
3.
Issue 02 (2021-06-30)
NO TE
Numbers 1 and 2 indicate the DIP switch settings of T/H sensors. The DIP switch of the T/H
sensor on the front door is set to 2, and that of the T/H sensor on the rear door is set to 1.
Toggle Toggle
Switch 1 Switch 2
ON OFF
OFF ON
Log in to the ECC800-Pro WebUI as an administrator.
Add a T/H sensor.
Table 5-9 Adding a T/H sensor
Path Parameter
Choose Device
System Attribute
Settings >
Device Type
Device
Management
and click Add
Connect To
Device.
Communica
tions Port
Device
Address
Click Test Connect to check whether the T/H sensor connects to the ECC800-
Pro properly.
– If the connection is normal, click Confirm. The connected devices are
displayed in the Number of connected devices list.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Toggle Toggle
Switch 3 Switch 4
OFF OFF
OFF OFF
Setting
Select Sensor from the drop-down list box.
Select T/H sensor from the drop-down list
box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
In this example, device address is set to 1.
During actual configuration, set the device
address for the T/H sensor based on the
actual situation.
Toggle Toggle
Switch 5 Switch 6
OFF OFF
OFF OFF
121