Table of Contents
Advertisement
Power Supply 1-1
(POW1-1)
Power Supply 0-1
(POW0-1)
Power Supply 1-0
(POW1-0)
Power Supply 0-0
(POW0-0)
Figure 4.12-3 GS4000-320E (AC) Powered On
!
(2) Powering Off the GS4000-320E (AC)
Set all the switches attached to the device to OFF.
WARNING: THE GS4000 HAS MULTIPLE POWER SOURCES WHEN IT HAS A REDUNDANT
!
!
520-10-026-30X
Caution: Wait at least two seconds before restarting the GS4000 once it has been
powered off.
POWER SUPPLY, EACH HAVING A SEPARATE SOURCE OF MAIN POWER.
WHEN POWERING OFF THE DEVICE, MAKE SURE THAT ALL THE POWER
SWITCHES AND CIRCUIT BREAKERS ATTACHED TO IT ARE SET TO OFF.
Caution: While the access indicator of BCU (ACC LED) is lit, the memory card is being
accessed. DO NOT pull out a memory card or turn off the power switch while
the memory card is being accessed. If so, you could permanently damage the
memory card.
Caution: In the following cases, never turn off the switch of the device until the STATUS
LED of BCU changes from "Green (blinking)" to "Green (ON)". Otherwise, the
device might be damaged:
1. Initial power entry (with the memory card mounted) after the device is
unpacked.
2. .During the update of software
GS4000 Installation Guide Revision 4.00
4. Set to ON.
3. Set to ON.
2. Set to ON.
1. Set to ON.
ON
OFF
Power Switch
4-49
Advertisement
Table of Contents
